Volkswagen Polo Service & Repair Manual: General Information
| The following descriptions also apply to Left Rear Cigarette
Lighter -U3-, Right Rear Cigarette Lighter -U7-, Rear Cigarette
Lighter -U9-, 12 V Socket 2 -U18-, 12 V Socket 3 -U19-, 12 V
Socket 4 -U20-, Cigarette Lighter 2 -U25- and 12 V Socket 5
-U26- if they are illuminated. |
Caution
| Using force to remove cigarette lighter sockets
without illumination can result in damage to the
mounting sleeve retainers. |
| The Cigarette Lighter Release Tool -T40148- can only
be used to remove cigarette lighter sockets with
illumination. |
| The puller is not capable of releasing the retainers
on power sockets without illumination. |
| Sockets without illumination usually cannot be
removed without damage. |
|
Caution
| Using force to remove cigarette lighter sockets
without illumination can result in damage to the
mounting sleeve retainers. |
| The Cigarette Lighter Release Tool -T40148- can only
be used to remove cigarette lighter sockets with
illumination. |
| The puller is not capable of releasing the retainers
on power sockets without illumination. |
| Sockets without illumination usually cannot be
removed without damage. |
|
| On some vehicle equipment levels, socket illumination is via
Light Emitting Diode (LED) instead of a bulb. These LEDs are
integrated with the illumination housing and cannot be serviced
or replaced separately. |
| Various versions of illumination housing with bulb exist.
One version allows separate replacement of the illumination
bulb, and another where the bulb cannot be serviced or replaced
separately. In this case, the entire illumination housing must
be replaced. |
| There are different versions of the sockets and cigarette
lighter sockets due to different installation locations and
construction. The differences are primarily In the length and
type of electrical connectors. On sockets or cigarette lighter
sockets with an electrical cable pig tail, additional work may
be necessary to access the connector. |
|
Caution
Using force to remove cigarette lighter sockets
without illumination can result in damage to the
mounting ...
Other materials:
Corrective Action When Vehicle Pulls to One Side
Test Conditions Before and During the Road Test
–
Check all suspension components on front and rear axle for
damage.
–
Check tire pressure and correct if necessary.
– ...
Information stickers and plates
First read and observe the introductory information
and safety warningsSafety certificates, stickers and plates showing important
vehicle operation information are factory-fitted in the engine compartment and on
certain parts such as the tank flap, front passenger sun visor, the driver door
...
Checking the electrolyte level of the vehicle battery
Fig. 141 In the engine compartment: removing
the vehicle battery cover
First read and observe the introductory information
and safety warningsThe electrolyte level of the vehicle battery should be
checked regularly in high-mileage vehicles, in hot countries and in older vehicle
batteries. ...
© 2016-2026 Copyright www.vwpolo.net
