Volkswagen Polo Owners Manual: Checking and refilling the windscreen washer fluid level
Fig. 77 In the engine compartment: cap of washer fluid reservoir
First read and observe the introductory information
and safety warnings
The windscreen washer fluid level should be checked regularly and topped up as necessary.
A filter can be found in the feed throat of the washer fluid reservoir. The filter keeps large dirt particles away from the washer jets when refilling. The filter should only be removed for cleaning. If the filter is damaged or cannot be found when refilling, these dirt particles will reach the system and will block the washer jets.
- Open the bonnet
.
- The washer fluid reservoir is identified by the
symbol on the cap .
- Check whether there is enough windscreen washer fluid in the reservoir.
- To top up, mix clean water with a washer fluid recommended by Volkswagen . Observe the dilution instructions on the packaging.
- At low temperatures, add a special anti-freeze agent so that the fluid cannot freeze .
Recommended windscreen washer fluid
- For warm weather: summer windscreen wash - G 052 184 A1 - . Dilution 1:100 (1 part concentrate, 100 parts water) in the washer fluid reservoir.
- All-year washer fluid - G 052 164 A2 - . Dilution in winter to -18°C (0°F) approx. 1:2 (1 part concentrate, 2 parts water), otherwise dilute one part concentrate to four parts water (1:4) in the washer fluid reservoir.
Capacities
The windscreen washer fluid reservoir has a capacity of about 3.5 – 5.4 litres.
WARNING
- Use clean, clear water with a washer fluid recommended by Volkswagen.
- If necessary, add a suitable anti-freeze agent to the windscreen wiper fluid.
NOTICE
- Never mix other cleaning agents with the cleaning agents recommended by Volkswagen. This can cause the ingredients to separate and block the windscreen washer jets.
- Never mix up service fluids when refilling. Failure to observe this warning can result in serious malfunctions and engine damage.
Rain/light sensor
Fig. 75 Windscreen wiper lever: setting
the rain/light sensor Ⓐ
Fig. 76 Sensitive surface of the rain/light
sensor
First read and observe the introductory information
and safety warnings
...
Mirrors
...
Other materials:
Locking and unlocking the vehicle from the outside
Fig. 23 Buttons on the vehicle key
Fig. 24 Mechanical vehicle key
First read and observe the introductory information
and safety warnings
Function
Buttons to be used in the vehicle key
Action to be followed with key in the lock cylinder or
Unlockin ...
Special Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“.
...
Warning lamp and coolant temperature display
Fig. 138 Coolant temperature display in
instrument cluster: Ⓐ cold; Ⓑ normal; Ⓒ warning
First read and observe the introductory information
and safety warningsA display for the coolant temperature may be, depending
on the vehicle equipment, located in instrument cluster. In normal driv ...
