Volkswagen Polo Service & Repair Manual: Wheel, Balancing
- Wheel, Balancing on Stationary Balancing Machine
- Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
- Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
- Wheel Balancing, Rim Radial and Lateral Run-Out, Checking
Tires and Rims, Matching
If necessary repair flat spots from standing. Refer to
→ Chapter „Flat Spots, Correcting“.
–
Dismount the tire. Refer to ...
Wheel, Balancing on Stationary Balancing Machine
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire p ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Stowage
→ Contents
Observe any country-specific legislation when securing your vehicle in the
event of a breakdown.
Additional information and warnings:
Preparation for working in the engine compartment
...
Antenna Wires, Repairing
Aerial Cable Repair Set -VAS6720
Special tools and workshop equipment
required
Repair Set, Aerial Cable -VAS6720-
Checking the Antenna Wire. Refer to
Replacing the Tool Head. Refer to
...
Tires, Mounting, Wheels without and with Tire Pressure Monitoring System
Only trained personnel can perform the assembly work on
run-flat tires.
If equipped check the tire pressure monitoring sensor with
the vehicle diagnostic tester and if necessary replace.
–
Bring the t ...
