Driving through water on roads
IntroductionTaper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
Receiver/Dryer
Caution
Non-approved tools or materials such as leak sealing
additives can cause damage or malfunctions in the
system.
Only use tools and materials approved by the
manufactu ...
Start/stop system
Fig. 119 In the upper part of the centre
console: button for the start/stop system
First read and observe the introductory information
and safety warnings If the start/stop system is activated, the
engine will be switched off automatically when the vehicle is stationary. When required,
t ...