VW Polo manuals

Volkswagen Polo Owners Manual: Introduction

This chapter contains information on the following subjects:

 → Vehicle identification data

 → Engine data

 → Dimensions

 → Performance figures

The vehicle data sticker in the service schedule or the vehicle registration documents show which engine is installed in your vehicle.

All data in the official vehicle documents take precedence over these data. All data in this manual apply to the basic model. The figures may be different if additional equipment is fitted, for different models, for special vehicles and for other countries.

Additional information and warnings:

WARNING

Ignoring or exceeding the values given for the weights, payloads, vehicle dimensions and maximum speed could lead to accidents and serious injuries.
Technical data
...

Vehicle identification data
Fig. 15 A: Vehicle data sticker: example shows a vehicle with engine code CCZB ③. B: Type plate Fig. 16 Vehicle identification number First read and observe the introductory information and ...

Other materials:

Evacuating and Charging Valve, Low Pressure Side
Special tools and workshop equipment required Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VAS6234-   WARNING There is a dan ...

CAN Bus Wires, Repairing
Unshielded two-strand wiring -1- and -2- with a cross section of 0.35 mm2 or 0.5 mm2 can be used as CAN bus wiring. The color coding of CAN bus wires can be found in the following table:   ...

Checking with Expansion Valve, Receiver/Dryer and A/C Compressor Regulator Valve -N280-, Externally Regulated A/C Compressor
Specified Values   Note Connecting service station. Refer to → Chapter „Connecting Service Station“. Observe test requirements. Refer to → Chapter „P ...

© 2016-2026 Copyright www.vwpolo.net