Volkswagen Polo Service & Repair Manual: Snow Chains

Volkswagen Polo Service & Repair Manual / Whels, Tires, Whel Alignment / Snow Chains

Snow Chins, Assembly and Replacing

Snow chains may be mounted only on the drive wheels.

If the vehicle has AWD, then snow chains may be used on the front wheels only.

Snow chains are not possible with all wheel/tire combinations. Corresponding notes can be found in the vehicle parts certificate table.

If no special snow chain type is specified, a snow chain with small chain links can be used. Only chains which do not stand up more than 15 mm, including chain lock, may be applied on tire tread and inner sides.

With some models and certain wheel/tire combinations, only snow chains with small chain links can be used. Corresponding notes can be found in the vehicle parts certificate table.

The Legally Permitted Maximum Speed When Driving With Snow Chains is 50 km/h (31.06 mph).

Remove the snow chains before driving on snow-free roads. It does not make sense to leave them on because the handling characteristics become worse. During this, the tires are stressed unnecessarily and the chain wear is particularly high.

Wheel Bolts, Anti-Theft Wheel Bolt

Anti-Theft Wheel Bolts 1 - Anti-theft wheel bolts 2 - Cap 3 - ...

Emergency Wheels

Spare Wheel Notes If Necessary, Explain to the Customer the Information About Tires and Refer the Customer to the Owner's Manual. ...

Other materials:

Using the cruise control system
Fig. 123 On the left of the steering column: button and switch for the CCS First read and observe the introductory information and safety warnings Function Switch position, switch control Action Switching on the CCS. Switch ② i ...

Gear-change indicator
First read and observe the introductory information and safety warnings In some vehicles, the instrument cluster will show which gear should be selected while the vehicle is in motion to reduce fuel consumption. Display Meaning The c ...

General Information
In order to be able to force moisture and other contaminants out of refrigerant circuit, compressed air and nitrogen (to force moisture out of refrigerant circuit) are to be used. For the most part, blowing through the refrigerant circui ...