VW Polo manuals

Volkswagen Polo Service & Repair Manual: Magnetic Clutch High Pressure Switch -F118

  Note
For switching pressures, removing and installing switches and switch arrangement and version, see vehicle-specific refrigerant circuit.
Refer to → Rep. Gr.87.
   
Function:
Switches off A/C compressor when there is excessive pressure in the refrigerant circuit (approximately 32 bar (464 psi)).
 

Magnetic Clutch High Pressure Switch -F118

A/C Refrigerant High Pressure Switch -F23
  Note For switching pressures, removing and installing switches and switch arrangement and version, see vehicle-specific refrigerant circuit. ...

A/C Refrigerant Low Pressure Switch -F73
  Note For switching pressures, removing and installing switches and switch arrangement and version, see vehicle-specific refrigerant circuit. ...

Other materials:

Changing bulbs in the side turn signals
Fig. 188 Removing the side turn signal bulb Fig. 189 Side turn signal: changing the bulb First read and observe the introductory information and safety warnings Depending on the vehicle, the side turn signal may be located in the front wing or in the exterior mirror . Please contact a ...

Autogas
Fig. 133 In the upper section of the centre console: switch for Autogas First read and observe the introductory information and safety warnings When the vehicle is restarted, the last manually selected operating mode will be adopted automatically. If, for example, autogas mode was activa ...

Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must be fulfilled. The tire pressure must be OK. The tire profile must not be worn on one side. The tire profile must be at least 4 mm. ...

© 2016-2026 Copyright www.vwpolo.net