Volkswagen Polo Owners Manual: Introduction
This chapter contains information on the following subjects:
→ Indicator lamps
→ Turn signal and main beam lever
→ Switching lights on and off
→ Lights and vision – functions
→ Masking or switching over headlights for driving abroad (travel mode)
→ Headlight range control, instrument and switch lighting
→ Interior and reading lights
Observe any country-specific regulations when using vehicle lighting.
The driver is responsible for the correct headlight position and the correct headlight setting.
Additional information and warnings:
- Exterior views
- Changing bulbs
WARNING
- Always switch the dipped beam headlights on if it is dark, raining or visibility is poor.
WARNING
- Always ensure that the headlights are adjusted correctly.
- Never use the main beam or the headlight flasher if other road users could be dazzled.
Lights
...
Indicator lamps
First read and observe the introductory information
and safety warnings
Indicator lamps in the instrument cluster
Lit up
Possible cause
Solution
...
Other materials:
Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
Ashtray in the drink holder
First read and observe the introductory information
and safety warnings
Fig. 104 Removable ashtray
To use, place the removable ashtray in one of the drink holders in the front
centre console or in the rear centre console .
Opening and closing the ashtray
To open, lift the ashtray cove ...
Refrigerant Circuit, Tracing Leaks, with Electronic Leak Detector -VAG1796
Note
This repair manual describes different methods for detecting
leaks in the refrigerant circuit. These methods have been tested
and result in success when used correctly.
If when searching for compressed air / Nit ...
