Volkswagen Polo Service & Repair Manual: Extraction and Charging System Safety Regulations
| Make sure the shut-off valves are closed before connecting
the charging system to the air conditioning system. |
| Make sure the process is finished before disconnecting the
charging system from the A/C system. This prevents any
refrigerant from escaping into the atmosphere. |
| Once the purified refrigerant from the charging system has
been transferred to an external compressed-gas cylinder, close
the hand shut-off valves at the cylinder and charging system. |
| Do not expose charging system to moisture or use it in a wet
environment. |
| Disconnect from power supply before performing service work
on the charging system. |
| Never use an extension cable on account of the fire hazard.
If the use of an extension cable is unavoidable, the minimum
cross-section should be 2.5 mm2.
|
| In case of fire, remove the external cylinder. |
| Entrained oil from the air conditioning system drawn by the
suction unit into the measurement vessel supplied is
subsequently to be transferred to a sealed container as it
contains a small quantity of refrigerant. It must not be
released into the environment. |
| Following shutdown, A/C service station is to be secured to
stop it rolling away. |
|
|
|
Secure vessels to prevent them falling over!
Secure upright cylinders to stop them falling over and
cylinders lying flat to stop them rolling away.
...
A/C Service Station -VAS6007A- (and further or current A/C
Service Station)
Refer to the Workshop Equipment Catalog.
...
Other materials:
Test after driving for 10 minutes
First read and observe the introductory
information and safety warnings
Reconnect the tyre filler hose and check the tyre pressure on the tyre
pressure display ⑥.
1.3 bar (19 psi / 130 kPA) and lower:
Do not drive on! The tyre cannot be sealed adequately
with the breakdown set.
...
Information stickers and plates
First read and observe the introductory information
and safety warningsSafety certificates, stickers and plates showing important
vehicle operation information are factory-fitted in the engine compartment and on
certain parts such as the tank flap, front passenger sun visor, the driver door
...
Overview - Tire Pressure Monitoring Sensor without Valve
1 -
Valve Cap
2 -
Nut
Individual component of -item 7-
→ Item
Tightening specification. Refer to
→ Anchor.
Always replace if removed
3 -
W ...
© 2016-2026 Copyright www.vwpolo.net
Handling Pressure Vessels
A/C System and Refrigerant R134a Safety Precautions