Volkswagen Polo Service & Repair Manual: Warranty Test, Performing
WARNING
| Do not check or charge batteries that have a visual
indicator that is bright yellow. Jump starting must not
be used! |
| There is a risk of explosion during testing,
charging or jump starting. |
| These batteries must be replaced. |
|
| – |
Select “Warranty Test”. |
| – |
Select “inside the vehicle” or “outside of the vehicle”. |
| – |
Select “at the battery pole” or “at the battery jump start
terminal”. |
| – |
Scan in the battery 2D code or manually select battery type
and current strength. |
| – |
Measure the temperature. Hold the temperature sensor
approximately 5 cm above the battery pole until the temperature
is stable. |
| – |
Print out the test report if necessary. |
|
Special tools and workshop equipment
required
Battery Tester -VAS6161-
WARNING
...
WARNING
Do not check or charge batteries that have a visual
indicator that is bright yellow. Jump starting must not
...
Other materials:
Cigarette Lighter Illumination Bulb -L28-, Removing and Installing
Note
On some vehicle equipment levels, socket illumination is via
Light Emitting Diode (LED) instead of a bulb. These LEDs are
integrated with the illumination housing and cannot be serviced
or replaced separately.
...
Introduction
This chapter contains information on the following subjects:
→ The dangers of assuming an incorrect sitting position
→ Correct sitting position
→ Mechanical controls on the front seats
→ Adjusting the head restraints
→ Removing and fitting head restra ...
Filling the tank with petrol or diesel
Fig. 130 In the right-hand side of the
vehicle at the rear: tank flap open
Fig. 131 Open tank flap with tank cap attached
to the holder
First read and observe the introductory information
and safety warnings Switch off the engine, ignition and the
mobile telephone before filling the ta ...
© 2016-2026 Copyright www.vwpolo.net
Battery Test, Performing using Battery Tester -VAS6161
Maintenance Test, Performing