VW Polo manuals

Volkswagen Polo Service & Repair Manual: Vibration, Road Test, Performing Before Balancing

Volkswagen Polo Service & Repair Manual / Whels, Tires, Whel Alignment / Handling Problems / Vibration / Vibration, Road Test, Performing Before Balancing

If a vehicle comes to the workshop with the complaint “vibration”, a road test must be performed before balancing the wheels.
That way, information about the type of vibration can be obtained.
Observe at which speed range the disturbance takes place.
–  Raise the vehicle on the platform immediately after the road test.
–  Mark the component location on the tire.
   
Component Location of Tire Identification with ...
Left front tire LF
Right front tire RF
Left rear tire LR
Right rear tire RR
–  Remove the wheels from the vehicle.
–  Balance the wheels.
   
Vibration, Causes for Vibration
There are many causes for vibration. Vibration can also be caused by tire wear, among other things. Tire wear caused by driving does not always develop evenly over th ...

Vibration, Vibration Control System
Expanded functions can be performed using Hunter RFT33VAG Road Force Touch™ Wheel Balancer -VAS6230B4- in addition to the previously known balancers. ...

Other materials:

Introduction
This chapter contains information on the following subjects:  → Indicator lamps  → Turn signal and main beam lever  → Switching lights on and off  → Lights and vision – functions  → Masking or switching over headlights for driving abroad (travel mode) ...

Indicator lamp
First read and observe the introductory information and safety warnings Lit up Possible cause Solution There is a defective bulb in the vehicle's exterior lighting. Change the defective bulb. Several warning and indicat ...

Commercially Available Tools and Materials
  Note This list outlines the testers, tools and materials required for expert refrigerant circuit repair work.   Caution Non-approved tools or materials such as leak sealing additiv ...

© 2016-2026 Copyright www.vwpolo.net