Volkswagen Polo Owners Manual: Retrofitting two-way radios

Volkswagen Polo Owners Manual / Vehicle care and maintenance / Accessories, modifications, repairs and renewal of parts / Retrofitting two-way radios

First read and observe the introductory information and safety warnings

You will need an external aerial to use a two-way radio in the vehicle.

Any retrofit installation of electrical or electronic equipment in the vehicle will affect its vehicle type approval. Under certain circumstances, this can negate the type approval for the vehicle.

Volkswagen has approved the vehicle for use with two-way radios subject to the following conditions:

Correct installation of external aerial,

A maximum transmitting power of 10 watts.

The equipment can only operate at maximum range with an external aerial.

Check first with a qualified workshop if you wish to use a two-way radio with a transmitting power of over 10 watts. A qualified workshop is familiar with the technical options for retrofitting. Volkswagen recommends using a Volkswagen dealership for this purpose.

Please comply with relevant legislation and the instructions and information given in the operating manuals for radio equipment.

WARNING

If radio equipment is not secured or not properly secured in the vehicle, it could be flung though the interior during a sudden driving or braking manoeuvre, or in the event of an accident. This can cause injuries.

While the vehicle is in motion, always secure radio equipment properly outside the airbag deployment zone or stow them away safely.

CAUTION

If two-way radios that are not connected to an external aerial are used, electromagnetic radiation in the vehicle could exceed limit values and thus be a health hazard for drivers and other vehicle occupants. This also applies to external aerials which have not been correctly installed.

Two-way radios should only be used in the vehicle if an external aerial is properly connected.

Repairs and faults in the airbag system

First read and observe the introductory information and safety warningsRepairs and modifications must always be carried out according to Volkswagen specifications . Modifications and repairs to ...

Information stored in the control units

First read and observe the introductory information and safety warningsYour vehicle is factory fitted with electronic control units which are responsible for engine and gearbox management. The con ...

Other materials:

Leaks or Internal Damage, for Example Noises or No Output
Note For vehicles with an electrically-driven A/C compressor, de-energize the high voltage system before removing the A/C compressor. Refer to → Electrical System Hybrid; Rep. Gr.93. – Dischar ...

Running-in
First read and observe the introductory information and safety warningsPlease follow the regulations concerning running-in new parts. Running in a new engine Any new engine has to be run in during the first 1,500 kilometres. During its first few hours of running, the internal friction in the ...

Coolant Fan Control Module -J293
Note Available in different construction styles, some installed on coolant fan -arrows-. This control module switches on and off the A/C clutch and therefore the A/C compressor. It switche ...