Volkswagen Polo Owners Manual: Introduction
This chapter contains information on the following subjects:
→ Opening or closing the windows electrically
→ Electric windows – functions→ Roll-back function for the electric windows
Additional information and warnings:
- Central locking system
- Cleaning and caring for the vehicle exterior
WARNING
- The electric windows should only be opened or closed when you are sure that nobody is in their operating area.
- Never leave children or people requiring assistance alone in the vehicle when the vehicle is locked. The windows can no longer be opened in an emergency.
- Always take all vehicle keys with you every time you leave the vehicle. The windows can still be operated using the buttons several minutes after the ignition has been switched off, provided that the driver door and front passenger door are not opened.
- When transporting children on the rear bench seat, the rear electric windows should always be deactivated using the safety button so that they cannot be opened or closed.
NOTICE
Electric windows
...
Opening or closing the windows electrically
Fig. 32 In the driver door: buttons for
the front and rear electric windows with one-touch opening and closing.
First read and observe the introductory information
and safety warnings
Buttons i ...
Other materials:
Checklist
Using seat belts :
Check the condition of all seat belts regularly.
Keep the seat belts clean.
Avoid allowing any foreign bodies or fluids
to get on to the seat belt or latch plate or into the slot for the seat belt
buckle.
Do not trap or damage the seat belt and
latch ...
Introduction
This chapter contains information on the following subjects:
→ Positive and earth jump lead connection points
→ How to start the engine using jump leads
If the engine fails to start because the vehicle battery is flat, the flat
battery can be connected to the battery of anothe ...
Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
