Volkswagen Polo Service & Repair Manual: Industrial Dirt Remover
| Industrial Dirt Remover -ABS 600 000 10- |
| Industrial Dirt Remover -ABS 600 000 10- is used to remove
surface rust (metal dust) from the vehicle body. The product is
used undiluted. |
Caution
| The product contains organic and inorganic acids. |
| Protective gloves and glasses must be worn when
handling this product! |
|
 Note
| Before starting to apply, it is necessary to read the safety
measures and advice in the safety data sheet. |
| Even for products which are not required to be labeled by
law, the usual safety measures must be observed for chemical
emissions. |
| During application, observe the following: |
| The temperature of the cleaner and vehicle body must not
exceed 25 °C (77 °F) (do not expose the vehicle and product to
direct sunlight). |
| After washing the vehicle, the product is applied to the
vehicle body using a brush or sponge. Let the product work for
approximately 10 minutes (do not increase the exposure time,
otherwise the paint or plastic parts may corrode). Do not dry
the product. |
| Rinse and wash the body/vehicle with plenty of water. |
| If the vehicle is still not clean after one use, repeat the
cleaning procedure. |
|
|
|
| Chemical composition |
Highly-effective cleaning
combination out of organic and inorganic acids, surface-active agents
and water. |
| Color |
Water-clear,
transparent/clear, colorless fluid |
| pH value |
1 |
| Density at 15 °C (59 °F) |
EN ISO 12185 1.076 ± 0.015 g/ml |
| The guaranteed shelf life of 36 months from date of
manufacture. Use no later than the date indicated on the label
and store in original container at +15 °C to +30 °C (59 ° to 86
°F). |
|
|
|
Definition:
Plastic Cleaner -D 195 850 A1-
Edition 04/2009
Product Description
P ...
Other materials:
Wear Spots
A wear spot is a flat spot on the tread of the tires that
can be caused by extreme braking maneuvers on subsurface such as
asphalt.
At the same time a tire during the braking maneuver is
rubbed at selective points which ...
Working on Airbag System
WARNING
When working on the airbag system (pyrotechnic
components, Airbag Control Module -J234-, wiring), the
ground cable must be disconnected with the ignition
switched on.
...
Two-Part HS Wet-in-Wet Filler
Definition:
Two-Part HS Wet-in-Wet Filler -LVM 013 008 A4-, light gray
Two-Part HS Wet-in-Wet Filler -LVM 013 905 A4-, black
Edition 03/2015
Product Description
...
© 2016-2026 Copyright www.vwpolo.net
Plastic Cleaner
SprayMax System