Volkswagen Polo Service & Repair Manual: Service Test, Performing

Volkswagen Polo Service & Repair Manual / Battery, Starter, Generator, Cruise Control / Battery, Checking / Battery Tester -VAS6161 / Service Test, Performing

Note

The printed test results can differ depending on the software version.

Read the Battery Tester -VAS6161- Operating Instructions.

WARNING

Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

–	Select “Service Test”.

–	Select “at the battery pole” or “at the battery jump start terminal”.

–	Select the type of battery: “standard”, “AGM”, “2*6V” or “Gel”.

–	Select the “CCA”, “JIS”, “DIN”, “SAE”, “IEC” or “EN”.

–	Select battery value.

–	Measure the temperature. Hold the temperature sensor approximately 5 cm above the battery pole until the temperature is stable.

–	Start the test.

–	Print out the test report if necessary.

Maintenance Test, Performing

WARNING Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not ...

Explanation of Test Results

1 - Type of test. 2 - Battery test result. 3 - Measured voltage ...

Other materials:

Valve, Removing and Installing, Metal Valve
Special tools and workshop equipment required Torque Wrench -VAG1410- Perform the Following: Removing – Remove the Tire Pressure Monitoring Sensor. Refer to ...

Introduction
This chapter contains information on the following subjects: → Information stickers and plates → Using the vehicle in other countries and continents → Radio reception and aerials → Volkswagen repair information → Declaration of conformity → ...

Tires, Aging
Even tires that look in good shape, new or hardly use and have sufficient tread depth and that are older than 6 years, can age caused by moisture and winter conditions. Tire test show that through continual development, new rubber ...