Volkswagen Polo Owners Manual: Driving a loaded vehicle

Volkswagen Polo Owners Manual / Transporting items / Driving tips / Driving a loaded vehicle

First read and observe the introductory information and safety warnings

For good vehicle handling when driving a loaded vehicle, please observe the following:

Stow all items of luggage securely .

Accelerate carefully and gently.

Avoid sudden braking and driving manoeuvres.

Brake earlier than you normally would.

If applicable, observe the information concerning driving with a trailer .

If applicable, heed the information about driving with a roof carrier .

WARNING

Moving loads can severely impair the vehicle's stability and driving safety, which can cause accidents and severe injuries.

Secure objects properly to prevent them from sliding.

Use suitable straps when securing heavy objects.

Engage the rear seat backrests securely in an upright position.

Driving with an open tailgate

First read and observe the introductory information and safety warnings Driving with an open tailgate is particularly dangerous. Ensure that the open tailgate and any objects are secured properly ...

Vehicle-specific weight ratings

First read and observe the introductory information and safety warnings All data in the official vehicle documents take precedence over these data. All data in this manual apply to the basic mode ...

Other materials:

Vehicle Registration Documents Since 01/10/2005
The implementation of EU guideline 1999/37/EG "Vehicle registration documents" in national legislation and legal data protection requirements have made the introduction of new, fraud resistant registration documents necessary. ...

Evacuating and Charging Valve, Low Pressure Side
Special tools and workshop equipment required Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VAS6234- WARNING There is a dan ...

Wires with Cross Section up to 0.35 mm 2, Repairing
Special tools and workshop equipment required Crimping Pliers - .35-2.5mm -VAS1978/1A- Wiring Harness Repair - Crimping Head - .35-2.5mm -VAS1978/1-1- When repairing wires with a cross- ...