Volkswagen Polo Service & Repair Manual: Contact Housings and Connectors, Repair Information
 Note
| Observe general notes for repairs on the vehicle electrical
system. Refer to
→ Chapter „Vehicle Electrical System, General Repair
Information“. |
| Allocation of crimp contacts with correct fit to contact
housing is performed according to the part number stamped in on
the contact housing. Part numbers of contact housing are listed
in conjunction with the respective crimp contacts with correct
fit in plate 198 (electrical connecting elements) in Parts
Catalog. |
| Damaged contact housings must always be replaced. |
| New contact housings may be ordered via OTC Kassel. |
|
First, open or release if necessary the secondary lock of
the contact housing. Refer to
→ Chapter „Contact Housings, Releasing and Disassembling“.
...
Other materials:
Laws and Regulations
Note
The laws and regulations listed below are applicable in
Germany. Different or additional laws and regulations may apply
in other countries.
Addresses in other countries can be obtained from the
relevant au ...
Tire Pressure Sensor and Metal Valve, Removing and Installing
Special tools and workshop equipment
required
Torque Wrench 1410 -VAG1410- and Torque Wrench 1331 5-50Nm
-VAG1331-
–
Place metal valve with rubber seal through rim from inside.
...
Ashtray in the drink holder
First read and observe the introductory information
and safety warnings
Fig. 104 Removable ashtray
To use, place the removable ashtray in one of the drink holders in the front
centre console or in the rear centre console .
Opening and closing the ashtray
To open, lift the ashtray cove ...
© 2016-2026 Copyright www.vwpolo.net
Contacts in Contact Housing, Repairing