Volkswagen Polo Service & Repair Manual: Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and
Installing
| – |
Push the wheel electronics -1-
into the bed.
|
| – |
Install on the valve from the back with a microencapsulated
screw -item 8-
→ Item |
Note
| Replace the microencapsulated screw. |
| Tighten the microencapsulated screw to 4 Nm on all models. |
| Special tools and workshop equipment
required |
| Torque Wrench 1410 -VAG1410- and Torque Wrench 1410 Insert -
Accessory Kit -VAG1410/1- |
| Tightening Specifications. Refer to
→ Anchor. |
|
|
|
Special tools and workshop equipment
required
Torque Wrench 1410 -VAG1410- and Torque Wrench 1331 5-50Nm
-VAG1331-
...
WARNING
If tire sealant was used, then the wheel electronics
on that particular wheel must be replaced.
...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Seat covers
→ Cleaning cloth seat covers, fabric trim and Alcantara upholstery
→ Cleaning and caring for natural leather covers
→ Cleaning leatherette upholstery
→ Cleaning stowage compart ...
Additional Information Sources
Technical Service Handbook outlining action to be taken to
rectify current problems.
For the repair manual for model-specific repair work. Refer
to
→ Heating, Ventilation and Air Conditioning; Rep. Gr.87.
...
Filling the tank with petrol or diesel
Fig. 130 In the right-hand side of the
vehicle at the rear: tank flap open
Fig. 131 Open tank flap with tank cap attached
to the holder
First read and observe the introductory information
and safety warnings Switch off the engine, ignition and the
mobile telephone before filling the ta ...
© 2016-2026 Copyright www.vwpolo.net
