Volkswagen Polo Service & Repair Manual: Battery, Charging
WARNING
Batteries that have a light yellow visual indicator
do not have to be tested or charged. Jump starting must
not be used! |
There is a risk of explosion during testing,
charging or jump starting. |
These batteries must be replaced. |
|
Battery Tester Charger Kit -GRX3000VAS- output - setup
performed (unit number, date/time). Refer to Battery Tester
Charger Kit -GRX3000VAS- Operating Instructions. |
– |
General information, checking. Refer to
→ Chapter „Battery Tester Charger Kit -GRX3000VAS- General
Description“. |
– |
Open the hood or open the cover if the battery is installed
somewhere else. |
– |
Visually inspect the battery. Refer to
→ Chapter „Visual Inspection“. |
– |
Determine if it is a “standard” battery (wet battery) or an
“AGM” battery. |
– |
Close all the vehicle doors. |
Note
The battery temperature must be at least 10 °C (50 °F). |
Refer to the Battery Tester Charger Kit -GRX3000VAS-
Operating Instructions for more information. |
Perform Charging Procedure |
– |
Turn off all electrical consumers. |
– |
Turn off the ignition and remove the key. |
– |
Clamp the red charging clamp “+” of the charger to the
positive battery terminal. |
Note
In the case of vehicles with a start/stop function and an
installed Battery Monitoring Control Module -J367-, the black
charging clamp (-) must be connected to the body ground. The
start/stop system will malfunction if it is connected to the
negative terminal on the battery. |
– |
Connect the black charging clamp “-” of the charger to the
negative battery terminal. |
– |
Connect the Battery Tester Charger Kit -GRX3000VAS- battery
charger to a grounded socket. |
– |
Switch the “ON/OFF” switch on the Battery Tester Charger Kit
-GRX3000VAS- battery charger to “ON”. |
– |
Select the charge mode “automatic” or “manual.”. |
– |
Select the test: “inside the vehicle” or “outside of the
vehicle”. |
– |
Determine if it is a “standard” battery or an “AGM” battery. |
– |
Select the type of test: “Warranty” or “other”. Note any
other additional details (depending on the type of test). |
Note
Refer to the Battery Tester Charger Kit -GRX3000VAS-
Operating Instructions for more information. |
If necessary, go through all the menu points when performing
a “Warranty” test. Refer to Warranty Service Circulars. |
The Battery Tester Charger Kit -GRX3000VAS- battery charger
checks the battery and starts the charging process. The display
then show one of three results with the exact charging time. |
|
|
|
Result: |
Measure: |
Battery good |
The battery can be used again. |
Charging is required |
The test shows a low state of charge. |
The charging process begins and the exact duration for the
charging will be displayed |
The cold start performance and the remaining charging time
are displayed and updated regularly. |
|
Replace the battery. |
Battery faulty. The charging
process is interrupted. Replace the battery. |
Note
If other malfunction messages or text displays, other than
the ones already mentioned, appear in the display on the Battery
Tester Charger Kit -GRX3000VAS- battery charger, then refer to
chapter. Refer to
→ Chapter „Battery Tester Charger Kit -GRX3000VAS-
Troubleshooting“. |
WARNING
If the battery starts to vent gas heavily, stop the
charging process. Press the “Stop” button on the front
side. |
|
After the charging and testing process is completed, the
Battery Tester Charger Kit -GRX3000VAS- battery charger will
display “battery good” or “replace the battery” and the total
charging time. |
Depending on the individual circumstance (Warranty Claim,
Repair Order, Evaluation and File), there are three possible
messages |
Produce a test code (possible only after automatic charging
and testing). |
Print last test result (for Warranty) |
Display the last test result. |
Note
Refer to the Battery Tester Charger Kit -GRX3000VAS-
Operating Instructions for more information. |
|
|
|
Only Volkswagen approved chargers may be used to charge
batteries in Volkswagen vehicles. Only the Battery Tester
Charger Kit -GRX3000VAS- charger is used in the USA ...
Sometimes the display shows the malfunction or the messages
based on the condition.
The following is a list of the most frequent displayed
mess ...
Other materials:
Fold Corrosion Servicing Notes
Corrosion on the Fold Edges, for Instance on the Hood, Door
or also the Rear Lid
–
Remove the corroded areas with
→ Chapter „Pneumatic Brush Grinder Set -VAS6446-“ or
→ Chapter „Brush Grinder Set ...
A/C Compressor with A/C clutch
Caution
Non-approved tools or materials such as leak sealing
additives can cause damage or malfunctions in the
system.
Only use tools and materials approved by the
manufactu ...
Using the vehicle in other countries and continents
First read and observe the introductory information
and safety warningsThe vehicle has been manufactured specifically for a particular
country and complies with the registration regulations that applied in that country
at the time of vehicle production.
If the vehicle is to be sold in anothe ...
© 2016-2023 Copyright www.vwpolo.net
