Volkswagen Polo Service & Repair Manual: Aquaplus Touch-Up System
| Touch-Up Additive for Aquaplus -LVM 030 000 A2- |
| The touch-up Additive for Aquaplus is especially suited for
painting Aquaplus water-based base paint. This serves to
simplify the touch-up process. |
| Primed and filled surfaces (two-part HS filler) |
| Hardened, solvent-resistant, well-preserved and sanded old
paint or factory paints |
| Suitable pre-treatment materials: |
| Dependent on the object and base surface, according to our
structure recommendations. |
|
|
|
| Pre-treatment of base surfaces: |
| – |
Clean the factory or old paint or two-part HS filler
thoroughly with Silicone Remover -LVM 020 000 A5- or Silicone
Remover, Long -LVM 020 100 A5-. |
|
|
|
| – |
Dry-sand with rotary sander with P400-500 grit and dust
extraction or wet-sand with water-resistant P800-1000 grit
sandpaper. |
|
|
|
| – |
Sand the painted area of the undamaged original paint with
P1000-1200 grit sandpaper. |
|
|
|
| – |
Use a suitable cleaning agent before again reworking to
ensure a clean and residue-free surface. |
|
|
|
| – |
Allow wet-sanded surfaces and cleaned surfaces to dry
completely. |
|
|
|
| Dilution is not required. |
|
|
|
| – |
Processing viscosity 4 mm for +20 °C (68 °F) , German
Industry Standardization 53211 |
| – |
The processing viscosity of the product is ready for
immediate application. |
|
|
|
| – |
Set spray nozzle (see manufacturer's information):
“Compliant” 1.2 to 1.3 mm. |
| – |
Set spray nozzle (see manufacturer's information): “HVLP”
WSB/1.3 mm. |
| – |
Set spray pressure (see manufacturer's information):
“Compliant” to 2.0 to 2.5 bar. |
| – |
Set atomizing pressure (see manufacturer's information):
“HVLP” 0.7 bar. |
|
|
|
| – |
Depending on the color and covering capacity, apply 3 to 5
spray applications of the adjusted Aquaplus water-based base
paint using reduced pressure (0.8-1.5 bar) to the damaged areas. |
 Note
| The inlet pressure for this touch-up system should be
reduced as described here. Disregard the instructions provided
by the manufacturer. |
|
|
|
| Evaporating time before clear lacquer application |
| Let ventilate at +20 °C (68 °F) room temperature for 15 to
20 minutes. |
| The following make it possible to reduce the ventilation
time: |
| Applying matt to a painted surface can be accelerated by
blowing with a spray gun, forced, IR or oven drying. |
| Blowing with a spray gun is also possible after waiting at
least five minutes. |
| The drying time is at least 5 minutes. |
|
|
|
| Can be painted over with: |
Note
| The product should not be used “pure”. |
|
|
|
| Personal Protective Equipment: |
| Note the safety data sheets |
| Wear the personal protective equipment during application |
|
|
|
| Flashpoint: |
above +23 °C (73.4 °F) |
| The guaranteed shelf life of Touch-Up Additive for Aquaplus
-LVM 030 000 A2- is 24 months from date of manufacture. Use no
later than the date indicated on the label and store in original
container at +20 °C (68 °F) |
|
|
|
| The optimal storage temperature is between +5 °C and +35 °C
(41° and 95 °F). |
Note
| Temperatures that do not fall within this range can cause
damage to the product. |
|
|
|
Definition:
Water-Based Pearl Effect Base Paint -LPW 040 ...-
Water-Based Heliochrome Base Paint -LHW 046 ...-
...
Definition:
Water-Based Solid Mixed Paint -LWM 083 ...-
Water-Based Metallic/Pearl Effect/Special Effect Mixed Paint
...
Other materials:
Refrigerant Circuit Connections with Valve for Switches
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
Refer to
→ Rep. Gr.87.
...
Tyre Pressure Loss Indicator
Fig. 124 In the stowage compartment on
the front passenger side: button for the Tyre Pressure Loss Indicator
First read and observe the introductory information
and safety warnings The Tyre Pressure Loss Indicator uses data
from the ABS sensors and other functions to check the speed of rot ...
Single Wire Seals, Installing
Note
Single wire seals prevent the penetration of water and dirt
into the contact housing. They are installed, for example, in
the engine compartment and must be reinstalled after a repair.
Single wire seal is crimpe ...
© 2016-2026 Copyright www.vwpolo.net
Aquaplus System (Pearl Effect and Heliochrome)
Aqua Premium System