Volkswagen Polo Owners Manual: Warning and indicator lamps
First read and observe the introductory information
and safety warnings
Depending ont eh vehicle equipment scope, an electrohydraulic or an electromechanic steering system may be fitted.
| Lit up | Possible cause | Solution |
|---|---|---|
 |
Electrohydraulic or electromechanic steering reduced. | The steering should be checked by a qualified workshop as soon as possible. |
| If the yellow warning lamp remains off after the ignition has been restarted and you have driven a short distance, you do not need to consult a qualified workshop. | ||
| The vehicle battery has been disconnected and reconnected. | Drive a short distance at a speed of 15 – 20 km/h (10 – 12 mph). |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.
WARNING
- Never ignore any illuminated warning lamps or text messages.
- Stop the vehicle as soon as possible and when safe to do so.
NOTICE
Introduction
This chapter contains information on the following subjects:
→ Warning and indicator lamps
→ Information on steering
Additional information and warnings:
Starting and s ...
Information on steering
First read and observe the introductory information
and safety warnings The steering should be locked every time
you leave the vehicle to make it more difficult for the vehicle to be stolen.
...
Other materials:
Two-Part Filler
Definition:
Two-Part Filler -LLS MAX 202 M2-, medium gray
Edition 03/2013
Product Description
The Two-Part Filler -LLS MAX 202 M2-, (medium gray) is a
high-quality two-part H ...
Wiring Harness Repair Set -VAS1978
The Wiring Harness Repair Set -VAS1978- makes optimal repair
quality possible in the realm of vehicle electronics. Using the
tools, repairs affecting harness connectors and for breaks in
wiring can be performed. For this purpose, complete repair wires
wi ...
Flat Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“.
...
