Wiring
Vehicle Diagnostic Tester, ConnectingAdhesive Surface Pretreatment when Replacing Laser-Soldered Roofs
Dry sand the cataphoretic primer on the roof adhesive surface
-item 6-
→ Item down to the bare metal using P180 sandpaper.
–
Dry sand the roof pillar adhesive surface
...
Tire Pressure Monitoring Sensor without Metal Valve, Removing and
Installing, Service Version
Special tools and workshop equipment
required
Torque Wrench -VAG1410-
Perform the Following:
Removing
–
Remove the tire from the disc wheel. Refer to
͛ ...
Indicator lamp
First read and observe the introductory information
and safety warnings
The central locking system indicator lamp is located in the driver door .
Depending on the vehicle equipment level, the vehicle may have an anti-theft
alarm and a SAFELOCK mechanism .
After locking ...