Volkswagen Polo Owners Manual: Underseal
First read and observe the introductory information
and safety warnings
The underside of the vehicle is coated to protect it from corrosion and damage. The protective coating on the underside of the vehicle could be damaged when driving. Volkswagen therefore recommends that the protective coating on the underside of the vehicle and on the running gear should be checked regularly and repaired if necessary.
CAUTION
- Never apply underseal or anti-corrosion coatings to the exhaust pipes, catalytic converter, heat shields or other vehicle components that become hot.
De-icing door lock cylinders
First read and observe the introductory information
and safety warningsVolkswagen recommends the use of genuine Volkswagen spray
with lubricating and anti-corrosive properties to de-ice the lock c ...
Cleaning the engine compartment
First read and observe the introductory information
and safety warningsThe engine compartment of any motor vehicle is a hazardous
area .
The engine compartment should be cleaned by a qualified w ...
Other materials:
Repair Instructions for the Underbody and Stone Chip Protection
Note
The underbody and stone chip protection structure must be
restored back to its original layer strength and appearance
during a repair.
Water drain holes must remain free.
All threade ...
Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Introduction
This chapter contains information on the following subjects:
→ Socket in the vehicle
Electrical equipment can be connected to the socket in the vehicle.
The devices connected must be in good condition and fault-free.
Additional information and warnings:
Cigarette lighter
Acce ...