Volkswagen Polo Service & Repair Manual: Reinforced Shock Absorbers and Coil Springs
| Reinforced shock absorbers and coil springs on the vehicle
rear axle reduce pitching motions between the vehicle and the
trailer. If not already installed in the factory, these shock
absorbers and springs can often be retrofitted at authorized
Volkswagen dealers. Shock absorber and spring allocation. Refer
to the
→ Electronic Parts Catalog (ETKA). |
| Stabilization aids can also reduce pitching and rolling
motions. These aids are available from authorized Volkswagen
dealers in most European countries and can be installed there. |
|
|
|
| Operating and Driving Tips |
 Note
| Always read and follow the operating and driving tips in the
vehicle owner's manual. |
|
|
|
Because towing places higher demands on the engine cooling
system, the cooling system is enhanced in vehicles that have
factory-installed trailer hitches, if necessar ...
Tongue Weight Specifications
The tongue weight specifications on the trailer hitch type
label are inspection values and only valid ...
Other materials:
Refrigerant Circuit Connections with Valve for Switches
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
Refer to
→ Rep. Gr.87.
...
Introduction
This chapter contains information on the following subjects:
→ Socket in the vehicle
Electrical equipment can be connected to the socket in the vehicle.
The devices connected must be in good condition and fault-free.
Additional information and warnings:
Cigarette lighter
Acce ...
Technical Requirements
Factory-Installed Trailer Hitch
If the vehicle was already delivered from the factory with a
trailer hitch, all of the technical and legal requirements for
towing a trailer have already been taken into account.
Note that a »13-pin« trailer ...
© 2016-2026 Copyright www.vwpolo.net
Engine Cooling
General Information