Volkswagen Polo Service & Repair Manual: Midtronics Battery Tester -MCR340VKT-, Troubleshooting
| Sometimes the display shows the malfunction or the messages
based on the condition. |
| The following is a list of the most frequent displayed
messages together with suggested solutions. |
 Note
| Refer to the MCR340V Operating Instructions for messages not
listed here. |
|
|
|
| Display Message |
Measure |
| No display |
| – |
Make sure the battery tester terminals are attached securely
to the battery terminals. |
| – |
Make sure the battery pole is tightened to the tightening
specification and is not corroded. |
| – |
Charge battery. Refer to
→ Chapter „Battery Tester Charger Kit -GRX3000VAS-“. |
|
| System noises |
| – |
Switch off all electrical consumers. |
| – |
Wait until all electrical equipment, which are monitored by
the vehicle electrical system control module, are switched off.
|
| – |
Disconnect any doubtful or standard production electrical
equipment from the vehicle electrical system. |
|
| Wait a few minutes and then perform the test again. Refer to
→ Chapter „Battery, Testing using Midtronics Battery Tester
-MCR340VKT-“. |
Note
| If the test was performed at the battery jump start terminal
and the message still does not go away, then perform the test
directly on the battery. |
|
Requirements
WARNING
Read and follow the Safety Precautions when working
with batteries. Refer to
...
WARNING
Batteries that have a light yellow visual indicator
do not have to be tested or charged. Jump starting must
...
Other materials:
Refrigerant Circuit with Expansion Valve and Evaporator
1 -
Evaporator
2 -
Expansion Valve
3 -
Valve for extracting, filling and measuring
4 -
Receiver/dryer with dryer bag/dryer cartridge
...
Coolant specification
First read and observe the introductory information
and safety warningsThe cooling system is filled at the factory with a mixture
of specially prepared water and at least 40% coolant additive G 13
(TL-VW 774 J). The coolant additive is dyed purple. This mixture of water and coolant
additive ...
How to start the engine using jump leads
Fig. 191 How to connect the jump
leads when starting vehicles without start/stop system: discharged battery Ⓐ and
battery providing assistance Ⓑ
Fig. 192 How to connect the jump
leads when starting vehicles with start/stop system: discharged battery Ⓐ and
battery providing assistance ...
© 2016-2026 Copyright www.vwpolo.net
Battery, Testing using Midtronics Battery Tester -MCR340VKT
Current Draw Test