Volkswagen Polo Owners Manual: Masking or switching over headlights for driving abroad (travel mode)
First read and observe the introductory information
and safety warnings
If you have to drive a right-hand drive vehicle in a left-hand drive country, or vice versa, the asymmetric dipped beam headlights may dazzle oncoming traffic. Therefore, the headlights must be masked or switched over if you are driving abroad.
The alignment of the headlights can, depending on the vehicle, be adjusted with
the help of the Travel mode menu option in the Settings menu in the instrument cluster
. When travel mode is switched on, the indicator lamp
flashes after the ignition is switched
on for approximately 5 seconds each time.
In vehicles in which the headlights cannot be adjusted via the menu, stickers should be applied to certain parts of the headlight lenses, or the headlights should be adjusted by a qualified workshop. A qualified workshop can provide you with further information. Volkswagen recommends using a Volkswagen dealership for this purpose.
Stickers may only be used on the headlights for a limited period. Please contact a qualified workshop for a permanent alteration. Volkswagen recommends using a Volkswagen dealership for this purpose.
Lights and vision – functions
First read and observe the introductory information
and safety warnings
Parking light
Depending on the vehicle equipment level, when the parking lights (left and right
turn signals) are switche ...
Headlight range control, instrument and switch lighting
Fig. 69 Next to the steering wheel: control
for instrument and switch lighting ① and headlight range control ②
First read and observe the introductory information
and safety warnings
① In ...
Other materials:
Stowage compartment
on the front passenger side
Fig. 97 Stowage compartment on the front
passenger side
Fig. 98 Open stowage compartment on the
front passenger side
First read and observe the introductory information
and safety warnings
Opening and closing the stowage compartment
To open, pull up the opening lever .
To close ...
Checklist
Never carry out any work on the engine or in the engine compartment
if you are not familiar with the requisite procedures and general safety requirements,
or if you only have access to incorrect operating equipment, service fluids,
and unsuitable tools . The work should be carried ou ...
Declaration of conformity
First read and observe the introductory information
and safety warningsThe individual manufacturer declares herewith that the
following products conform, at the time of vehicle production, with the basic requirements
and other relevant laws and regulations, including FCC Part 15.19, FCC Part 1 ...
