Volkswagen Polo Owners Manual: Declaration of conformity
First read and observe the introductory information
and safety warnings
The individual manufacturer declares herewith that the following products conform, at the time of vehicle production, with the basic requirements and other relevant laws and regulations, including FCC Part 15.19, FCC Part 15.21 and RSS-Gen Issue 1:
Radio-based equipment
- Electronic immobilizer.
- Vehicle key.
Electrical equipment
- 12-volt socket.
Volkswagen repair information
First read and observe the introductory information
and safety warningsVolkswagen Service information and official Volkswagen
repair information can be purchased from the following addresses:
Cu ...
Declaration of conformity for wheels and tyres
First read and observe the introductory information
and safety warningsTyres fitted in the vehicle meet the requirement of BIS
and comply with the requirements under the Central Motor Vehicle Rule ...
Other materials:
Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Tires, Mounting, Run-Flat Tires and Ultra High Performance Tires
Only trained personnel can perform the assembly work on
run-flat tires and ultra high performance tires.
If equipped check the tire pressure monitoring sensor with
the vehicle diagnostic tester and if necessary replace.
...
Fastening and unfastening seat belts
Fig. 50 Inserting the seat belt latch
plate into the buckle
Fig. 51 Removing the latch plate from
the buckle
First read and observe the introductory information
and safety warnings
If worn properly, seat belts hold the vehicle occupants in the correct sitting
position during an accident ...
