Volkswagen Polo Owners Manual: Introduction
This chapter contains information on the following subjects:
→ Drink holders in the centre console
Bottle holder
Bottle holders for bottles containing up to 1.5 litres are located in the open stowage areas of the driver and front passenger doors.
Additional information and warnings:
- Cleaning and caring for the interior
WARNING
- Do not place any hot drinks in a drink holder. Hot drinks in a drink holder could be spilled and cause scalding in any sudden braking manoeuvre or accident.
- Ensure that drink bottles or any other objects do not enter the driver footwell and obstruct the pedals while the vehicle is in motion.
- Never place heavy cups, food or any other heavy items in the drink holder. These heavy objects could be flung through the vehicle interior during an accident and cause serious injuries.
WARNING
- Never leave closed drink bottles in an extremely hot or extremely cold vehicle for extended periods.
NOTICE
Drink holder
...
Drink holders in the centre console
Fig. 102 In the front centre console:
drink holders
Fig. 103 Drink holder in the rear centre
console: folding out the drink holder
First read and observe the introductory information
and saf ...
Other materials:
Headlight range control, instrument and switch lighting
Fig. 69 Next to the steering wheel: control
for instrument and switch lighting ① and headlight range control ②
First read and observe the introductory information
and safety warnings
① Instrument and switch lighting
When the headlights are switched on, the brightness of the instrument ...
Cleaning and caring for the dash panel, wooden trims and plastic parts
First read and observe the introductory information
and safety warnings
Moisten a clean, lint-free cloth with water and clean the parts.
Treat plastic parts inside and outside the vehicle and the dash panel
with a special solvent-free plastic cleaning and care product
that has been a ...
Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
