Volkswagen Polo Service & Repair Manual: Heated Oxygen Sensor, Replacing
- 4-Pin Heated Oxygen Sensor (HO2S), Removing and Installing
- 6-Pin Universal Oxygen Sensor, Removing and Installing
- Oxygen Sensor Unit Protective Pipes
- Special Tools
Protecting
Caution
Missing protection leads to the electrical system
damage.
Note
...
4-Pin Heated Oxygen Sensor (HO2S), Removing and Installing
Note
Do not repair the heated oxygen sensor wires. Repairing may
result in malfunctions.
Use the faulty sensor as a guide ...
Other materials:
Wheel, Balancing on Stationary Balancing Machine
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Warning and indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine oil level is too low.
Switch off the engine. Check the engine oil level .
Fl ...
Introduction
This chapter contains information on the following subjects:
→ Indicator lamps
→ Start/stop system
→ Hill Hold Assist
Additional information and warnings:
Volkswagen information system
Braking, stopping and parking
Battery
Wh ...
