Volkswagen Polo Owners Manual: Checklist
Before getting into the vehicle, close all Velcro fasteners that could touch the cloth seat covers and fabric trims. Open Velcro fasteners can cause damage to cloth seat covers and fabric trims.
Avoid the direct contact of sharp-edged items and accessories to the upholstery and fabric trims in order to prevent damage. Accessories include zips, studs, rhinestones on clothing or belts.
Dust and grit in upholstery pores, folds and seams should be removed regularly so that no permanent damage is caused to the surface of the seats by scratching.
Always check whether garments are colourfast to prevent damage to the upholstery. This is especially important for light-coloured upholstery.
Please note the following for the cleaning and maintenance of the seat covers :
NOTICE
- Follow the instructions on the checklist.
Volkswagen recommends that stained upholstery is cleaned by a specialist company.
Seat covers
First read and observe the introductory information
and safety warnings ...
Cleaning cloth seat covers, fabric trim and Alcantara® upholstery
First read and observe the introductory information
and safety warningsCleaning upholstery on seat cushions with seat heating,
electrically adjustable seats, or seats containing airbag components ...
Other materials:
Evacuating and Charging Valve, Low Pressure Side
Special tools and workshop equipment
required
Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench
1783 - 1/4" Drive Ratchet -VAS6234-
WARNING
There is a dan ...
Indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
The start/stop system is not available. Automatic engine
switch-off is active.
Take your foot off the brake to start the ...
Opening and closing the electric panorama sliding/tilting glass roof
Fig. 33 In the roof: turn the switch to
open and close
Fig. 34 In the headliner: push the switch
to tilt and pull the switch to close
First read and observe the introductory information
and safety warnings
The rotary switch must be in the basic position ① before the electric panorama
...
