Volkswagen Polo Service & Repair Manual: Blender

Volkswagen Polo Service & Repair Manual / General Paint Information / Original Products / SprayMax System / Blender

Definition:

Blender -LLS MAX 009-

Edition 10/2008

Product Description

The Blender -LLS MAX 009- matches the overlapping areas or the edges from the existing paint to the new paint for proper vehicle spot painting. The raw material base has specific resin and solvent combinations.

Properties:

Application-oriented product-specific aerosol formulation

Constant atomizing pressure

Aerosol distribution

Professional painting result

Ideal for spot repair

Easy, time-saving processing

Especially suitable for touch-up repairs with two layer finishes and two-part one-coat finishes

Exceptional etching ability

Polishes well

Produces seamless edges on touch-up surfaces

Application Instructions

Application

Recommended for:

Spot repairs and touch-ups

Suitable base surfaces:

Immediately apply after spraying the Two-Part Clear Coat -LLS MAX 210- or two-part top coat onto the overlapping areas on the touch-up surface.

The base surface in the tapering off/overlapping areas should be sufficiently matted with a sanding pad (P2000-P4000).

Pretreatment:

No special tasks are necessary immediately before apply the blender.

Processing

Note

For work safety, wear appropriate, personal protective equipment:

Breathing mask type: A2/P2

Latex or nitrile protective gloves, for example

Application type “coat”

–	In several spray applications, spray onto the spray mist of either the two-part clear coat or two-part top coat until a uniform transition forms.

–	The two-part clear coat or two-part top coat do not require drying.

Note

If the spray application is interrupted, make sure that the valve above the spray head is empty.

Caution

For work safety, wear appropriate, personal protective equipment.

Note the safety data sheets as well as the warnings on the label of the spray nozzle.

Dispose of the empty spray cans as recyclable material.

Characteristics

Blender

Solid content:	4.8 %
Yield:	Approximately 0.5 m² / spray can
Gloss level:	not applicable
VOC value:	766 g/L, 306 g/can

Storage

The guaranteed shelf life of 36 months from date of manufacture. Use no later than the date indicated on the label and store in original container at +20 °C (68 °F).

Blender

Silicone Remover, Long -LLS MAX 008

Definition: Silicone Remover, Long -LLS MAX 008- Edition 10/2008 Product Description ...

Bonding Agent

Definition: Bonding Agent -LLS MAX 015-, plastic Edition 10/2012 Product Description ...

Other materials:

Introduction
This chapter contains information on the following subjects: → Controls for the air conditioning system → Controls for the heating and fresh air system → Information on the air conditioning system → Vents → Air recirculation mode ...

Retrofitting two-way radios
First read and observe the introductory information and safety warningsYou will need an external aerial to use a two-way radio in the vehicle. Any retrofit installation of electrical or electronic equipment in the vehicle will affect its vehicle type approval. Under certain circumstances, thi ...

Brake fluid
Fig. 117 In the engine compartment: cap on the brake fluid container First read and observe the introductory information and safety warnings Brake fluid will gradually absorb water from the surrounding air. The brake system will be damaged if there is too much water in the brake fluid. T ...