VW Polo manuals

Volkswagen Polo Service & Repair Manual: Battery Tester Charger Kit -GRX3000VAS- Troubleshooting

Sometimes the display shows the malfunction or the messages based on the condition.
The following is a list of the most frequent displayed messages together with suggested solutions.
  Note
Refer to the Battery Tester Charger Kit -GRX3000VAS- Operating Instructions for messages not listed here.
   
Display Message Measure
Check the connection
–  Make sure the battery charger terminals are attached securely to the battery terminals.
–  Make sure the battery pole is tightened to the tightening specification and is not corroded.
Terminals connected? Tester safety function.
–  Connect the terminals to the battery before charging.
System noises
–  Switch off all electrical consumers.
–  Wait until all electrical equipment, which are monitored by the vehicle electrical system control module, are switched off.
–  Remove the key.
–  Disconnect any doubtful or standard production electrical equipment from the vehicle electrical system.
 
Wait a few minutes and repeat the charging process. Refer to → Chapter „Battery, Charging“.
   
Battery, Charging
Requirements   WARNING Batteries that have a light yellow visual indicator do not have to be tested o ...

Solar Battery Maintainer -VAS6102A
Solar Battery Maintainer -VAS6102A- Maintenance Charging Solar Battery Maintainer -VAS6102A- General Description The Solar Battery ...

Other materials:

Checklist
Carry out the steps in the specified order : With the engine at operating temperature, park the vehicle on a level surface to ensure that the engine oil reading is correct. Switch off the engine and wait a few minutes for the engine oil to flow back into the sump. Open the ...

Introduction
This chapter contains information on the following subjects:  → Warning and indicator lamps  → Engine oil specification  → Checking the engine oil level and refilling engine oil  → Engine oil consumption  → Changing engine oil Additional information and w ...

Heel and Toe Wear
Heel-and-toe wear is step-like wear of individual tread blocks, due to which an increased rolling noise can develop. The heel-and-toe wear is caused by the uneven distortion of the tread blocks in the contact patch. Heel-and-toe wear appears in more extr ...

© 2016-2020 Copyright www.vwpolo.net