Volkswagen Polo Service & Repair Manual: Wiring Eyelets, Repairing
Special tools and workshop equipment
required |
Torque Wrench 1331 5-50Nm -VAG1331- |
Note
Do not use rust remover, contact spray or grease because the
lack of friction will cause the torque to be exceeded when
installing and this will lead to the threaded connection
breaking. |
The gray sanding pads are for slight contamination and
suitable for "soft surfaces". The red sanding pads are for heavy
contamination and suitable for "hard surfaces". |
WARNING
Risk of injury. Follow all Warnings and Safety
Precautions. Refer to
→ Chapter „Warnings and Safety Precautions“. |
|
|
|
|
– |
Insert the adapter in the wiring eyelet and sand off the
corrosion and contamination with circular motions. |
– |
Check the wiring eyelet and sand it again if necessary. |
|
|
|
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Note
Do not use r ...
Other materials:
Service Charging with Battery Charger -VAS5900
Special tools and workshop equipment
required
Battery Charger -VAS5900-
WARNING
Risk of injury. Follow all Warnings and Safety
Precautions. Refer to
→ ...
Empty Refrigerant Circuit
–
Remove malfunctioning component.
–
Remove the A/C compressor.
–
Remove oil drain plug from A/C compressor.
Note
To speed up refrigerant oil drai ...
Introduction
This chapter contains information on the following subjects:
→ Vehicle identification data
→ Engine data
→ Dimensions
→ Performance figures
The vehicle data sticker in the service schedule or the vehicle registration
documents show which engine is installed i ...
© 2016-2024 Copyright www.vwpolo.net