Volkswagen Polo Owners Manual: Wheel cover

Volkswagen Polo Owners Manual / Hubcaps / Wheel cover

Fig. 163 Removing press-on wheel covers

Fig. 164 Removing bolted-on wheel covers

First read and observe the introductory information and safety warnings

Removing and fitting press-on wheel covers

Take the box spanner and wire hook from the toolkit .

Insert the wire hook into one of the holes in the wheel cover.

Push the box spanner through the wire hook and remove the wheel cover in the direction of the arrow.

When a wheel cover is being fitted, it must be pushed onto the rims so that the hole for the valve is aligned with the tyre valve. Please ensure the cover fits securely all the way round.

Removing bolted-on wheel covers

The wheel cover is secured with wheel bolts and cannot be removed.

Remove the wheel bolts .

Remove wheel cover with wheel.

Fitting bolted-on wheel covers

Put the wheel in place.

Screw in the first wheel bolt at the height of the wheel valve ③ and tighten by hand.

Push the wheel cover through the first wheel bolt and fix it.

Fit the other 4 wheel bolts and tighten them hand-tight.

Tighten all wheel bolts with the correct torque .

NOTICE

The wheel cover can be firmly fixed and should not be removed using force.

Introduction

This chapter contains information on the following subjects: → Wheel cover → Wheel bolt caps Additional information and warnings: Tyre monitoring system Cleaning and car ...

Wheel bolt caps

Fig. 165 Removing the wheel bolt caps First read and observe the introductory information and safety warnings Take the wire hook from the vehicle toolkit . Insert the hook through th ...

Other materials:

Introduction
This chapter contains information on the following subjects: → Stowage → Contents Observe any country-specific legislation when securing your vehicle in the event of a breakdown. Additional information and warnings: Preparation for working in the engine compartment ...

ACC - Adaptive Cruise Control
Note On vehicles with ACC, the trim in the right cover section of the front bumper must not be painted if paint repairs or component replacements are performed. The ACC system is located behind this section therefore a coat of paint would ...

Leaks or Internal Damage, for Example Noises or No Output
Note For vehicles with an electrically-driven A/C compressor, de-energize the high voltage system before removing the A/C compressor. Refer to → Electrical System Hybrid; Rep. Gr.93. – Dischar ...