Fig. 166 Changing a wheel: loosening the wheel bolts
Fig. 167 Changing a wheel: anti-theft bolt and adapter
First read and observe the introductory information and safety warningsOnly the spanner delivered with the vehicle should be used to loosen the wheel bolts.
Only loosen the wheel bolts by approximately one turn before raising the vehicle with the vehicle jack.
If the wheel bolt is very tight, you may be able to loosen it by pushing down the end of the spanner carefully with your foot. Hold on to the car for support and take care not to slip.
Loosening the wheel bolts
Loosening the anti-theft wheel bolt
Important information about the wheel bolts
The design of the wheel rims and wheel bolts is matched to the factory-fitted wheels. If different rims are fitted, the correct wheel bolts with the right length and correctly shaped bolt heads must be used. This ensures that wheels are fitted securely and that the brake system works properly.
In certain circumstances, wheel bolts from a vehicle of the same model series may not be used.
Tightening torque for the wheel bolts
The tightening torque for wheel bolts for steel and alloy wheels is 120 Nm. The tightening torque should be checked with a torque wrench immediately after changing a wheel.
If the wheel bolts are corroded and difficult to turn, they must be replaced and the wheel hub threads cleaned before the tightening torque is checked.
Never grease or lubricate the wheel bolts or the threads of the wheel hub. This could cause them to loosen while the vehicle is in motion, even if the required torque setting is used.
WARNING
Incorrectly tightened wheel bolts can loosen while the vehicle is in motion and cause accidents, serious injury, and loss of control of the vehicle.Preserving Wax
Definition:
Preserving Wax -AKR 321 M15 4-
Preserving Wax -AKR 321 M16 10-
Edition 04/2009
Product Description
Preserving Wax -AKR 321 M15 4- and Prese ...
Tire Pressure Sensor and Metal Valve, Removing and Installing
Special tools and workshop equipment
required
Torque Wrench 1410 -VAG1410- and Torque Wrench 1331 5-50Nm
-VAG1331-
–
Place metal valve with rubber seal through rim from inside.
...
Refrigerant Circuit, Tracing Leaks, with Leak Detection System -VAS6196- or
Leak Detection Kit -VAS6201A- or Succeeding Model
Note
This repair manual describes different methods for detecting
leaks in the refrigerant circuit. These methods have been tested
and result in success when used correctly.
If when searching for compressed air / Nit ...