Volkswagen Polo Owners Manual: Wheel bolt caps
Fig. 165 Removing the wheel bolt caps
First read and observe the introductory
information and safety warnings
- Take the wire hook from the vehicle toolkit .
- Insert the hook through the opening in the cap and pull off in the direction of the arrow.
The caps protect the wheel bolts and must be replaced after changing the tyre.
The anti-theft wheel bolt has a separate cap. It only fits onto the anti-theft wheel bolts and not onto conventional wheel bolts.
Wheel cover
Fig. 163 Removing press-on wheel
covers
Fig. 164 Removing bolted-on wheel
covers
First read and observe the introductory
information and safety warnings
Removing and fitting press-on wheel ...
Changing a wheel
...
Other materials:
Checking with Expansion Valve, Receiver/Dryer and A/C Compressor Regulator
Valve -N280-, Externally Regulated A/C Compressor
Specified Values
Note
Connecting service station. Refer to
→ Chapter „Connecting Service Station“.
Observe test requirements. Refer to
→ Chapter „P ...
Towing a trailer
First read and observe the introductory information
and safety warnings
Headlight adjustment
Towing a trailer can raise the front end of the vehicle enough for the dipped
beam to blind other road users. Use the headlight range control to lower the light
cone as required. If you do not have ...
CAN Bus Wires, Repairing
Unshielded two-strand wiring -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
can be used as CAN bus wiring.
The color coding of CAN bus wires can be found in the
following table:
...
