Volkswagen Polo Service & Repair Manual: Wheel, Balancing
- Wheel, Balancing on Stationary Balancing Machine
- Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
- Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
- Wheel Balancing, Rim Radial and Lateral Run-Out, Checking
Tires and Rims, Matching
If necessary repair flat spots from standing. Refer to
→ Chapter „Flat Spots, Correcting“.
–
Dismount the tire. Refer to ...
Wheel, Balancing on Stationary Balancing Machine
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire p ...
Other materials:
Fold Corrosion Servicing Notes
Corrosion on the Fold Edges, for Instance on the Hood, Door
or also the Rear Lid
–
Remove the corroded areas with
→ Chapter „Pneumatic Brush Grinder Set -VAS6446-“ or
→ Chapter „Brush Grinder Set ...
Test after driving for 10 minutes
First read and observe the introductory
information and safety warnings
Reconnect the tyre filler hose and check the tyre pressure on the tyre
pressure display ⑥.
1.3 bar (19 psi / 130 kPA) and lower:
Do not drive on! The tyre cannot be sealed adequately
with the breakdown set.
...
Checking
–
Turn off the ignition.
–
Connect pressure gauge battery (A/C service station).
–
Take pressure gauge readings. There are two possible results
A and B.
&nbs ...
