VW Polo manuals

Volkswagen Polo Owners Manual: Washing the vehicle with a high-pressure cleaner

First read and observe the introductory information and safety warnings

Follow the instructions provided by the manufacturer when cleaning your vehicle using a high-pressure cleaner. This applies in particular to the pressure and the spraying distance .

Maintain sufficient distance to soft materials such as rubber hoses, insulation, and the ParkPilot sensors. The ParkPilot sensors are located in the rear bumper .

Never use concentrated jet nozzles or dirt blasters .

WARNING

The incorrect use of a high-pressure cleaner can cause visible and invisible long-term damage to tyres and other materials. This can cause accidents and serious injuries.

WARNING

After the car has been washed, the braking effect could set in later than normal and extend the braking distance as the brake discs and brake pads will be wet, or iced up in winter.

NOTICE

Washing the vehicle
First read and observe the introductory information and safety warningsThe longer substances such as insects, bird droppings, resinous tree sap, road dirt, industrial deposits, tar, soot or road s ...

Cleaning windows and exterior mirrors
First read and observe the introductory information and safety warningsCleaning windows and exterior mirrors Moisten the windows and exterior mirrors with commercially available, alcohol-based gl ...

Other materials:

Tread depth and wear indicators
Fig. 147 Tyre tread: wear indicators First read and observe the introductory information and safety warningsTread depth Difficult driving situations demand the deepest possible tread depth for the tyres and the same tread depth for the tyres on the front and rear axles. This applies in pa ...

Overview of the front passenger side
Fig. 9 Overview of the front passenger side (left-hand drive vehicles). The controls are mirrored in right-hand drive vehicles Key for : Vent   , Location of front passenger front airbag in the dash panel Key-operated switch in the stowage compartment for switch ...

Parking Aid Sensor, Painting
The following parameters must be met when painting to avoid malfunctions in the parking aid sensor (parking aid system): New Part, Painting Maximum coat thickness 125 µm; the coat thickness must always be measured ...

© 2016-2026 Copyright www.vwpolo.net