VW Polo manuals

Volkswagen Polo Service & Repair Manual: Warranty Test, Performing

  WARNING
Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not be used!
There is a risk of explosion during testing, charging or jump starting.
These batteries must be replaced.
–  Select “Warranty Test”.
–  Select “inside the vehicle” or “outside of the vehicle”.
–  Select “at the battery pole” or “at the battery jump start terminal”.
–  Scan in the battery 2D code or manually select battery type and current strength.
–  Measure the temperature. Hold the temperature sensor approximately 5 cm above the battery pole until the temperature is stable.
–  Start the test.
–  Print out the test report if necessary.
Battery Test, Performing using Battery Tester -VAS6161
Special tools and workshop equipment required Battery Tester -VAS6161-   WARNING ...

Maintenance Test, Performing
  WARNING Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not ...

Other materials:

Condenser
  Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system. Only use tools and materials approved by the manufactu ...

Tread depth and wear indicators
Fig. 147 Tyre tread: wear indicators First read and observe the introductory information and safety warningsTread depth Difficult driving situations demand the deepest possible tread depth for the tyres and the same tread depth for the tyres on the front and rear axles. This applies in pa ...

Vents
Fig. 128 In the dash panel: vents First read and observe the introductory information and safety warnings The vents   should be left open to ensure that the vehicle interior is sufficiently heated, ventilated and cooled. Turn the relevant thumb wheel (magnified view) in the required ...

© 2016-2022 Copyright www.vwpolo.net