VW Polo manuals

Volkswagen Polo Owners Manual: Warning lamp

Fig. 44 Warning lamp in the instrument cluster

First read and observe the introductory information and safety warnings
Lights up or flashes Possible cause Solution
The driver seat belt and, if the front passenger seat is occupied, the front passenger seat belt are not fastened. Fasten seat belts.
There are objects on the front passenger seat. Remove objects from the front passenger seat and stow them safely.

Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

A signal tone will be given for a few seconds if the seat belts are not fastened as the car pulls off and reaches a speed of more than approximately 25 km/h (15 mph), or if the seat belts are unfastened while the vehicle is in motion. The warning lamp will also flash.

When the ignition is switched on, the warning lamp will not go out until the driver and front passenger fasten their seat belts.

WARNING

Incorrectly fastened or unfastened seat belts increase the risk of severe or fatal injuries. Seat belts only offer the optimum level of protection when they are used properly.
Introduction
This chapter contains information on the following subjects:  → Warning lamp  → Frontal collisions and the laws of physics  → What happens to vehicle occupants who have not f ...

Frontal collisions and the laws of physics
Fig. 45 Unbelted occupants in a vehicle heading for a brick wall Fig. 46 Unbelted occupants in a vehicle striking a brick wall First read and observe the introductory information and safety ...

Other materials:

Charging Systems not Requiring a Permit
At this time, A/C service units for extracting, cleaning and filling refrigerant for motor vehicle A/C systems are available from various manufacturers. Charging systems not requiring a permit are ones used for transferring compressed ga ...

Fault in the function of the automatic gearbox
First read and observe the introductory information and safety warnings Emergency programme There is a fault in the system if all the displays on the instrument cluster for the selector lever positions have a light background. The automatic gearbox is running in an emergency programme. The ...

Coolant specification
First read and observe the introductory information and safety warningsThe cooling system is filled at the factory with a mixture of specially prepared water and at least 40% coolant additive G 13 (TL-VW 774 J). The coolant additive is dyed purple. This mixture of water and coolant additive ...

© 2016-2024 Copyright www.vwpolo.net