First read and observe the introductory information
and safety warnings
Lit up | Possible cause | Solution |
---|---|---|
![]() |
Handbrake is applied. | Release the handbrake . |
Brake system fault. | ![]() Obtain professional assistance . |
|
Brake fluid level is too low. | ![]() Check brake fluid level . |
|
Together with ABS indicator lamp
![]() |
Go to a qualified workshop. The vehicle can be braked without ABS. | |
![]() |
ESC switched off by the system. | Switch the ignition on and off. If necessary, drive a short distance. |
ESC fault. | Go to a qualified workshop. | |
In conjunction with ABS indicator lamp
![]() |
Go to a qualified workshop. The vehicle can be braked without ABS. | |
Vehicle battery has been reconnected. | Drive a short distance at a speed of 15 – 20 km/h (10 – 12 mph). If the indicator lamp remains lit up, the vehicle should be checked by a qualified workshop . | |
![]() |
In conjunction with ESC indicator lamp
![]() |
Go to a qualified workshop. The vehicle can be braked without ABS. |
In conjunction with warning lamp
![]() |
||
![]() |
TCS switched off manually. | Switch on TCS with button . Switch on TCS automatically by switching the ignition off and on. |
![]() |
Brake pedal not depressed. | To select a position, press the brake pedal . |
Flashes | Possible cause | Solution |
---|---|---|
![]() |
ESC/TCS is taking corrective action. | Remove foot from accelerator pedal. Adapt driving style to suit road conditions. |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.
WARNING
WARNING
NOTICE
Waxing and polishing the vehicle
First read and observe the introductory information
and safety warningsWaxing
Waxing protects the paintwork. You will need to re-wax the vehicle with a good
hard wax if water no longer clearly forms small drops
and runs off the paintwork when it is clean.
Even if a wax solution is used regul ...
Explanation of Test Results
1 -
Type of test.
2 -
Battery test result.
3 -
Measured voltage
4 -
Measured cold start value.
5 -
Cold st ...
Run-Flat System PAX, Support Ring
Dimensions
Overview of the most important dimensions:
Names
Example: 90-500(35) CLI A 1 876107
90 -
Designated width in millimeter ...