Volkswagen Polo Service & Repair Manual: Vibration, Road Test, Performing Before Balancing
| If a vehicle comes to the workshop with the complaint
“vibration”, a road test must be performed before balancing the
wheels. |
| That way, information about the type of vibration can be
obtained. |
| Observe at which speed range the disturbance takes place. |
| – |
Raise the vehicle on the platform immediately after the road
test. |
| – |
Mark the component location on the tire. |
|
|
|
|
Component Location of Tire |
Identification with ... |
| Left front tire |
LF |
| Right front tire |
RF |
| Left rear tire |
LR |
| Right rear tire |
RR |
| – |
Remove the wheels from the vehicle. |
|
|
|
There are many causes for vibration. Vibration can also be
caused by tire wear, among other things. Tire wear caused by
driving does not always develop evenly over th ...
Expanded functions can be performed using Hunter RFT33VAG
Road Force Touch™ Wheel Balancer -VAS6230B4- in addition to the
previously known balancers.
...
Other materials:
Electronic immobilizer
First read and observe the introductory information
and safety warnings The immobilizer helps to prevent the engine
from being started and driven with an unauthorised vehicle key.
There is a chip in the key. It automatically deactivates the immobilizer when
the vehicle key is inserted into ...
Introduction
This chapter contains information on the following subjects:
→ Ignition lock
→ Starting the engine
→ Stopping the engine
→ Electronic immobilizer
Notes in this chapter concerning the automatic gearbox are applicable
both for the automatic gearbo ...
Indicator lamps
Fig. 55 In the upper section of the centre
console: indicator lamp for disabled front passenger front airbag
First read and observe the introductory information
and safety warnings
Lit up
Location
Possible cause
Solution
Instrument c ...
© 2016-2026 Copyright www.vwpolo.net
Vibration, Causes for Vibration
Vibration, Vibration Control System