Rear view
Overview of the driver doorWheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Test after driving for 10 minutes
First read and observe the introductory
information and safety warnings
Reconnect the tyre filler hose and check the tyre pressure on the tyre
pressure display ⑥.
1.3 bar (19 psi / 130 kPA) and lower:
Do not drive on! The tyre cannot be sealed adequately
with the breakdown set.
...
Single Wire Seals, Installing
Note
Single wire seals prevent the penetration of water and dirt
into the contact housing. They are installed, for example, in
the engine compartment and must be reinstalled after a repair.
Single wire seal is crimpe ...