VW Polo manuals

Volkswagen Polo Service & Repair Manual: Valve, Removing and Installing, Rubber Valve

Make sure wheel rim is clean.
   
–  Using the Valve Fitting Tool Valve Fitting Tool -VAS6459--1-, insert a new tire valve.
–  Remove the valve insert.
–  Inflate tire to approximately 3 to 4 bar (43.5 to 58 psi), tire bead must slip audibly over rim hump when doing this.
–  Install the valve insert.
–  Check the tire pressure for specified pressure.
–  Balance the tire.
 

Valve, Removing and Installing, Rubber Valve

Valve, Removing and Installing, Valve Explanations
1. Valve Body 1 -  Valve body 2 -  Valve Insert 3 -  Valve cap ...

Valve, Removing and Installing, Metal Valve
Special tools and workshop equipment required Torque Wrench -VAG1410- Perform the Following: Remo ...

Other materials:

Refrigerant R134a Environmental Information
Vehicle air conditioning systems make use of the vaporization and condensation process. In this case, one works with a substance which boils easily, designated as refrigerant. The refrigerant employed is tetrafluoroethane R134a, which bo ...

Insulating glass windscreen
Fig. 71 Metal-coated windscreen for infrared reflection with communication window (blue area) First read and observe the introductory information and safety warnings Insulating glass windscreens have a coating which reflects infrared radiation. There is a non-coated area above the interior ...

Evacuating and Charging Valve, Low Pressure Side
Special tools and workshop equipment required Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VAS6234-   WARNING There is a dan ...

© 2016-2024 Copyright www.vwpolo.net