VW Polo manuals

Volkswagen Polo Service & Repair Manual: Valve, Removing and Installing, Metal Valve

Special tools and workshop equipment required
Torque Wrench -VAG1410-
Perform the Following:
Removing
–  Remove the Tire Pressure Monitoring Sensor. Refer to → Chapter „Tire Pressure Monitoring Sensor without Metal Valve, Removing and Installing, Service Version“.
   
–  Remove the nut -1- from the metal valve.
–  Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.
Installing
  Caution
Only apply the specified torque to tighten the nut for the metal valve. Tightening more is not permitted because it damages the seal.
 

Valve, Removing and Installing, Metal Valve

–  Tighten the nut -1- of the metal valve.
–  Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.
–  Install the Tire Pressure Monitoring Sensor. Refer to → Chapter „Tire Pressure Monitoring Sensor without Metal Valve, Removing and Installing, Service Version“.
Tightening Specifications
Refer to → Chapter „Overview - Tire Pressure Monitoring Sensor without Valve“
 

Valve, Removing and Installing, Metal Valve

Valve, Removing and Installing, Rubber Valve
Make sure wheel rim is clean.     –  Using the Valve Fitting Tool Valve Fitting Tool -VAS6459--1-, i ...

Run-Flat System PAX
...

Other materials:

Opening and closing the electric panorama sliding/tilting glass roof
Fig. 33 In the roof: turn the switch to open and close Fig. 34 In the headliner: push the switch to tilt and pull the switch to close First read and observe the introductory information and safety warnings The rotary switch must be in the basic position ① before the electric panorama ...

Checklist
Never carry out any work on the engine or in the engine compartment if you are not familiar with the requisite procedures and general safety requirements, or if you only have access to incorrect operating equipment, service fluids, and unsuitable tools   . The work should be carried ou ...

Instrument overview
Fig. 10 Instrument cluster in the dash panel: type 1 Fig. 11 Instrument cluster in the dash panel: type 2 First read and observe the introductory information and safety warnings Descriptions of the instruments or : Rev. counter (running engine speed in revolutions x 1,000 per mi ...

© 2016-2024 Copyright www.vwpolo.net