VW Polo manuals

Volkswagen Polo Owners Manual: Using a child seat on the rear seats

First read and observe the introductory information and safety warnings

When fitting a child seat to a rear seat, the position of the front seat must be adjusted to ensure that the child has sufficient space. Adjust the front seat according to the size of the child seat and child. Ensure that the front passenger can still maintain a correct sitting position .

Suitable child seats

The child seat must have been approved by the manufacturer for use on the rear bench seat with side airbag or combined curtain and side airbag.

Universal child seats in groups 0, 0+, 1, 2, or 3 as specified in ECE-R 44 can be fitted to the rear seats.

The outer seats are suitable for child seats with the ISOFIX system which are specially approved for this vehicle type by ECE-R 44.

Some child restraint systems have a support foot which rests on the vehicle floor. Child restraint systems with support foot may only be used on the outer seats on the rear bench seat. Child restraint systems with foot supports may not be used on the middle seat of the rear bench seat.

ISOFIX child seats approved for use on rear seats

There are different categories of ISOFIX child seats: universal, semi-universal and vehicle-specific.

WARNING

Any child in a child seat on the rear bench seat may sustain fatal injuries if they play with lockable seat belts that are not in use.
Using a child seat on the front passenger seat
Fig. 63 On the sun visor on the passenger side: airbag sticker First read and observe the introductory information and safety warnings Not all countries allow you to transport children on the f ...

Securing child seats with a seat belt
First read and observe the introductory information and safety warnings It is permissible to fasten child seats with universal written on the orange label to the seats using the seat belt, but on ...

Other materials:

Refrigerant R134a Environmental Information
Vehicle air conditioning systems make use of the vaporization and condensation process. In this case, one works with a substance which boils easily, designated as refrigerant. The refrigerant employed is tetrafluoroethane R134a, which bo ...

Masking or switching over headlights for driving abroad (travel mode)
First read and observe the introductory information and safety warnings If you have to drive a right-hand drive vehicle in a left-hand drive country, or vice versa, the asymmetric dipped beam headlights may dazzle oncoming traffic. Therefore, the headlights must be masked or switched over if ...

Introduction
This chapter contains information on the following subjects:  → Positive and earth jump lead connection points  → How to start the engine using jump leads If the engine fails to start because the vehicle battery is flat, the flat battery can be connected to the battery of anothe ...

© 2016-2026 Copyright www.vwpolo.net