Fig. 159 Removing the cover of the gearshift gate (left-hand drive) The controls are mirrored in right-hand drive vehicles
Fig. 160 Unlocking the selector lever lock manually
First read and observe the introductory information and safety warningsIf the power fails in the vehicle (for example if the battery has no charge) and the vehicle has to be pushed or towed, the manual release mechanism must be used to move the selector lever to the N position.
The manual release mechanism is located under the cover of the gearshift gate on the right-hand side, as seen from the direction of travel. A screwdriver, or other suitable object, is needed in order to unlock the selector lever lock.
Preparation
Removing the cover of the gearshift gate
Unlocking the selector lever lock manually
WARNING
Never move the selector lever out of the position P if the handbrake is not firmly applied. Otherwise the vehicle could move unexpectedly if it is stopped on an incline, which could lead to accidents and serious injuries. NOTICEThe automatic gearbox will become damaged if the vehicle is allowed to roll for a long period of time or at a high speed (for example while being towed) with the selector lever in position N and the engine switched off.
Wire Break with Dual Repair Point
Repair point with intermediate wire section
–
Free up wire intended for repair at two points
(approximately 20 cm to both sides of respective repair points).
–
If required, remove wiring harness wra ...
Changing bulbs in the side turn signals
Fig. 188 Removing the side turn
signal bulb
Fig. 189 Side turn signal:
changing the bulb
First read and observe the introductory
information and safety warnings
Depending on the vehicle, the side turn signal may be located in the front
wing or in the exterior mirror .
Please contact a ...
Cross-Section of a Radial Ply Tire
1 -
Tread Block
2 -
Tread Groove
3 -
Tread
4 -
Nylon Ply
5 -
Belt Layers
Consists mostly of steel
6 -
Bead Bundle
...