Volkswagen Polo Service & Repair Manual: Tire Pressure Monitoring Sensor with Valve, Removing and Installing
| – |
Remove the union nut -1-. |
| – |
Remove Tire Pressure Monitoring Sensor-2-
from rim well. |
Caution
| Clean the valve opening before installing the Tire
Pressure Monitoring Sensor. |
|
|
|
|
| – |
Insert the Tire Pressure Monitoring Sensor-2-
with new seal and sealing washer and press it on the spots
marked with the -arrows- into the
disc wheel (rim). |
| – |
Press the Tire Pressure Monitoring Sensor-2-
on the spots marked with the -arrows-
into the disc wheel (rim). |
| Screw on union nut -1- from
outside onto tire pressure sensor. |
|
|
|
| – |
Press the Tire Pressure Monitoring Sensor-1-
on the spots marked with the -arrows-
into the rim and tighten the union nut to 8 Nm. |
Caution
| Only tighten the union nut to the tightening
specification. |
| Sealing washer -2-
becomes slightly deformed when doing this. |
| The sealing washer can be installed one time only.
At every installation, replace the sealing washer and
rubber seal. |
| Do not tighten the union nut again. This will damage
the seal and it will leak. |
|
| Tightening Specifications |
| Refer to
→ Chapter „Overview - Tire Pressure Monitoring Sensor with
Valve“ |
|
|
|
Special tools and workshop equipment
required
Torque Wrench -VAG1410-
Perform the Following:
Remo ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Indicator lamps and fuel gauge
→ Filling the tank with petrol or diesel
→ Refuelling autogas
→ Capacities
→ Checks when filling the tank
The fuel cap is located at the re ...
Introduction
This chapter contains information on the following subjects:
→ Indicator lamps
→ Turn signal and main beam lever
→ Switching lights on and off
→ Lights and vision – functions
→ Masking or switching over headlights for driving abroad (travel mode)
...
Opening and closing the electric panorama sliding/tilting glass roof
Fig. 33 In the roof: turn the switch to
open and close
Fig. 34 In the headliner: push the switch
to tilt and pull the switch to close
First read and observe the introductory information
and safety warnings
The rotary switch must be in the basic position ① before the electric panorama
...
© 2016-2026 Copyright www.vwpolo.net
Tire Pressure Monitoring Sensor without Metal Valve, Removing and
Installing, Service Version