Volkswagen Polo Service & Repair Manual: Test Requirements
 Note
| The A/C system is functioning correctly when the air flowing
from the instrument panel vents has a temperature of 70C
or lower. |
| Setting on Climatronic “LO”. |
| Setting on A/C system “AC” on; “max”; “cold”. |
| The A/C system OBD cannot find malfunctions with the Vehicle
Diagnostic Tester in “Guided Fault Finding”. The measured value
block does not show any shut-off condition for the A/C
compressor (only on vehicles with “A/C system” OBD). |
|
|
|
Note
The A/C system is functioning correctly when the air flowing
from the instrument panel vents has a temperature of 70C
or lower.
...
Other materials:
A/C System, Operating after Charging
Caution
If it is suspected that chemicals were added to the
refrigerant circuit to seal leaks, do not connect the
A/C service station and do not extract the refrigerant.
...
Introduction
This chapter contains information on the following subjects:
→ Preparing the vehicle for working in the engine compartment
→ Opening and closing the bonnet
Always park the vehicle on a level and stable surface before carrying out any
work in the engine compartment.
The engine ...
Overview - Tire Pressure Monitoring Sensor with Valve
1 -
Tire Pressure Monitoring Sensor
Supplied complete as a service part
Removing and Installing. Refer to
→ Chapter „Tire Pressure Monitoring Sensor with Valve, Removing and
Installing“.
When battery ...
© 2016-2026 Copyright www.vwpolo.net
Possible Concerns