Volkswagen Polo Service & Repair Manual: Switches and Sensors on Refrigerant Circuit and Connections
- A/C Refrigerant High Pressure Switch -F23
- Magnetic Clutch High Pressure Switch -F118
- A/C Refrigerant Low Pressure Switch -F73
- Refrigerant Circuit Connections with Valve for Switches
- A/C Pressure Switch -F129
- High Pressure Sensor -G65
- A/C Pressure/Temperature Sensor -G395
- A/C Compressor Regulator Valve -N280
Evacuating and Charging Valve, Low Pressure Side
Special tools and workshop equipment
required
Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench
1783 - 1/4" Drive Ratchet -VA ...
A/C Refrigerant High Pressure Switch -F23
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
...
Other materials:
Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and
Installing
Overview, Beru System
WARNING
If tire sealant was used, then the wheel electronics
on that particular wheel must be replaced.
WA ...
Changing the bulb in the number plate light
Fig. 186 In the rear bumper:
number plate light
Fig. 187 Number plate light:
removing the bulb holder
First read and observe the introductory
information and safety warnings
A normal flat screwdriver can be used to remove the number plate light .
The actions sh ...
Towing Recognition Control Module -J345
General Information
The Towing Recognition Control Module -J345- recognizes
“trailer mode” when there is a power decrease of at least 5 W
→ Note and transmits this information to various control
modules via the CAN data bu ...
